Price:
(as of May 30, 2025 23:38:02 UTC – Details)
features :
• 1 -to -8 bidish translation switch.
• Supports hot insertion.
• Low standby current.
• 1 -to -8 bidish translation switch.
• Active-Lo reset input.
• Power up with all switch channels.
• I2C bus and SMBUS compatible.
• 5-Venus input.
• London-up performance is 100 mA per JESD 78, more than class II
PIN Details:
Power Pin:
• Vin – This is power pin. Since the sensor chip uses 3-5 VDCs. For power, the board, gives it the same power as the logic level of its microcontroller – such as 5Vs, for 5V, use 5V.
• GND – Common ground for strength and logic.
• i2C control-party pin:
• SCL – This is the I2C clock pin for chip, connect your microcontrollers to the I2C clock line.
• SDA – This is the I2C data pin for the chip, connect your microcontroller i2C data line.
• This is a reset pin to reset the RST – Multiplex chip. Draw by default, connect to the ground to reset
• A0 A1 A2 – These are address selection pins for multiplexes. By default, the multiplex address is at 0x70 and these three pins are pulled less. Add address to the address 0x71 – 0x77, connect them to VIN.
• The A0 is the lowest matched bit (if it is pulled high, it will increase the address by 1).
• A1 is the second best-mating bit (if it is pulled high, it will increase the address by 2).
• A2 is a third-time good-matched bit (if it has been pulled high, it will increase the address by 4).
I2C multiplex-side pin:
• SDX and SCX: There are 8 sets of SDX and SCX PINs, from SD 0/SC to SD7/SC7. These are multiplex pin. Each one is a completely different I2C bus set.
&bull
1 -to -8 bidish translation switch
Active-less reset input
Power up with all switch channels
I2C bus and SMBUS compatible
5-Ven tolerant input
